Eachine Novice 3 Binding Instructions for FrSky Non-EU from Cyclone FPV
MatekF411RX Firmware Used
(please scroll down to view videos that will go with these instructions)
Firmware 4.0.0
- After Flash - Verify SPI RX in RX Receiver Mode
- Verify RX Provider is FrSky X (for D16)
- Go to CLI
- Type bind_rx_spi (press enter)
- Put your radio in bind mode
- Type set frsky_x_rx_num (press enter)
- You should see your rx number match the rxnum on your radio.
- Once you verify, make sure to type save and press enter
- Immediately press exit on the radio to stop binding
- Go to the main screen on the radio and you should be bound.
Firmware 4.2.1
- After Flash - Verify SPI RX in RX Receiver Mode
- Verify RX Provider is FrSky X (for D16)
- Go to CLI
- Type bind_rx (press enter)
- Put your radio in bind mode
- Type set frsky_x_rx_num = (enter your rxnum value) (press enter)
- ie. set frsky_x_rx_num = 6 (press enter)
- You should see your rx number match the rxnum on your radio.
- Once you verify, make sure to type save and press enter
- Immediately press exit on the radio to stop binding
- Go to the main screen on the radio and you should be bound.
One issue that I am seeing with this is that the telemetry issue on the radio goes in and out with this method. I did notice this when the radio was close to the quad but once I moved it away, the issue stopped.
If you want to download the BF Backup and Dump files, click here
Video 1 of 2. This one is a quick tutorial. Video 2 is a complete start to finish.
Video #2 - Complete setup of X-Lite S ACCESS/ACCST and binding to Novice 3